Kawasaki Z650 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Anyone in here know the steps needed to take to do a clean air mod on the z650? Can’t find anything on YouTube or google other than reading something about block off plates? Thought those were used to get accurate readings for tuning. Building my Z out for stunting and the clean air mod is said to prevent oil from getting into the air box / down into the throttle bodies and down into the engine when you’re doing long wheelies. Not sure if cutting / plugging hoses is involved like I’ve seen for other bikes so not sure what’s all entailed to do that on the Z.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top