Kawasaki Z650 banner

1 - 7 of 7 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1 (Edited)
Hey all! I've been lurking for a while and finally decided to sign up. This forum has been a blessing to me. It has answered pretty much any question I had. If I didn't find an answer, I just tried it out myself.

My bike is 2019, and I have done a few upgrades as well as just personalization. I will list them below, as well as attach pics. If you have any questions, comments, or ideas, please respond below. Thanks!

- Doc


- bracket to tidy up rear fender/license/turn signals

- front windscreen (double bubble)

- handlebars (1st I tried pro-taper mix bars)

- bar end mirrors (2nd favorite upgrade)

- radiator cover

- flush mount front directionals

- mzs triangle design clutch & brake levers

- frame sliders

- rear spools

- delkevic full exhaust, 14" tri-oval, stainless
(By far my favorite mod. Loving the sound. Can post video if anyone is interested.
 

Attachments

·
Registered
Joined
·
74 Posts
How do you like those handlebars?
Do they help clamp down on vibration between the 4-6000 rpm range?

Are your rear spools metal?
I was afraid of installing my rubberized rear spools as I didnt want the one near the exhaust outlet to melt.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
I'm loving the handlebars. Finally feels right to me. I don't notice much change in vibration, but I didn't think it was particularly bad before I changed the bars. I did notice that the mx bars did have less vibration though, but they were too wide and I couldn't cut them down due to the room needed for levers and such.

My rear spools are aluminum I believe. Sliders are not (which is the way I want it).
 

·
Registered
Joined
·
4 Posts
Did you get a tunner it anything for that exhaust. I just put the 9" on and an now a little concerned that I might mess something up by the bike not being fully broken in and I don't have a tunner or anything like that.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #6
Did you get a tunner it anything for that exhaust. I just put the 9" on and an now a little concerned that I might mess something up by the bike not being fully broken in and I don't have a tunner or anything like that.
I have not had it tuned. I did the exhaust at around 1100 miles. I have noticed no negative consequences yet. Quite the opposite actually.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #7
How do you like those handlebars?
Do they help clamp down on vibration between the 4-6000 rpm range?

Are your rear spools metal?
I was afraid of installing my rubberized rear spools as I didnt want the one near the exhaust outlet to melt.
Right now I'm using clubman handlebars, and I like them even more than last ones.
 
1 - 7 of 7 Posts
Top