[jtm0n3y]

I’ve searched and can’t really find a definitive answer. Is there a way for me to show what codes a 2017 Z650 is showing without having to go to a dealer or hook up to the diagnostics port in the tail of the bike? Just got one for my girlfriend and fixed the previous owner’s sketchy suspension mods and after the first ride the engine engine light came on. Thanks!

 

[jtm0n3y]

So I did more research and found the answer to this on a ninja400 board. Push the left button on the display panel until your odometer is what’s displayed - you don’t want trip meters. Once your total odometer mileage is displayed press both the left and right buttons at the same time for about three seconds until the odometer reading changes to the two digit FI error code or codes (it will cycle through them lowest to highest of your bike has multiple) that your bike is observing/storing. Do these steps with the key in the on position but the bike not running. In my case I’m getting error code “33” which is an o2 sensor issue.

 

[Jadar671]

Great INFORMATION!!

 

[Jadar671]

Can anyone get to the admin and fix the spam???

 

[motodude]

Fantastic!!

 

[motodude]

I just tried it on my 2018 z650 and when you press both buttons for 3 seconds, it scrolls through the different tac dials. it doesn't show any codes.

 

[jtm0n3y]

If it scrolls through tac modes then you don’t have any codes...cause now that I fixed my code o2 code that’s how the bike acts when I hold both buttons down. If you have codes it WILL show them...if not, you get tac settings.

 

[amire]

Just tried to check for error codes on my european 2017 z. Mine never shows FI it just goes into "graphics" where I can change the speedometer-thingy.

 

[jtm0n3y]

Guys...if your fi/engine light isn’t on that means it’s not going to show codes.

 

[amire]

Thank you @jtm0n3y !

 

[byanrich]

I’ve searched and can’t really find a definitive answer. Is there a way for me to show what codes a 2017 Z650 is showing without having to go to a dealer or hook up to the diagnostics port in the tail of the bike? Just got one for my girlfriend and fixed the previous owner’s sketchy suspension mods and after the first ride the engine engine light came on. Thanks!

turn the bike on but do not start it.
press and hold both button on right and left for 5 seconds and the code will display on the screen where your OD reading is displayed.

 

[byanrich]

So I did more research and found the answer to this on a ninja400 board. Push the left button on the display panel until your odometer is what’s displayed - you don’t want trip meters. Once your total odometer mileage is displayed press both the left and right buttons at the same time for about three seconds until the odometer reading changes to the two digit FI error code or codes (it will cycle through them lowest to highest of your bike has multiple) that your bike is observing/storing. Do these steps with the key in the on position but the bike not running. In my case I’m getting error code “33” which is an o2 sensor issue.

o2 sensor issue is a common issue with z650.

 

[Carvalho Ciclismo Eduardo]

o2 sensor issue is a common issue with z650.

Only if you change the exhaust.