Kawasaki Z650 banner

R&G aero turn signal on vagabond fender eliminator

1657 Views 1 Reply 1 Participant Last post by  blkz650

Bought a lightech turn signal adapter but it does not fit z650 even though it says it does

Had to cut the rubber piece from the stock rear turn signal and put it on inside out

R&G turn signal goes to the inner metal plate, the flange nut it came with was too wide for the rubber piece so I used a non-flange nut.

Put on the outer metal plate and zip tie for extra security

Stock turn signal is 10watt so I used the 21.5 Ohm resistor from R&G

Anyone know any aftermarket turn signal adapter that works on our bike?

Also looking for some flush mount front turn signal recommandations
See less See more
  • Like
Reactions: 1
1 - 2 of 2 Posts
lightech turn signal adapter does work, I didn't use it correctly the first time
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.